High Performance Rework for Professionals!

The completely new Ersa Hybrid Rework System HR 550 features high-performance rework for professionals – with camera and software-assisted component placement, highly precise mechanics and a completely new, user-friendly operating software.

Ersa Hybrid Rework System HR 550: rework at highest level

During the last two decades, rework and repair of electronic assemblies was one of the most fascinating and demanding subject being talked about in the industry. On account of its wide application range and the reliably repeatable results, be it on mini-0201-chips, 120-mm-SMT-connector, SMT-Flip-Chips, THT-Pin-Grid-Arrays, BGAs, shrouds, plastic processor sockets etc., Ersa rework systems find themselves uncontested at the top of the market.

Computer-assisted placement of a QFP - green = pad, red = pin, blue = overlay

Highest Demands on Precision and Safety

With the Hybrid Rework System HR 550 Ersa makes available to professional users a high-performance unit, which fulfills the highest demands on precision and safety during rework of electronic assemblies. Its 1,500 W hybrid high-performance heating element can solder and desolder SMD components of up to 70 x 70 mm.

The 2,400 W infrared lower preheater ensures a homogeneous warming of the complete assembly. And when combined with the contact-free and the positive-contact temperature acquisition as well as the optimized process guidance, ideal conditions are in place for the desoldering and soldering process. In the HR 550, component removal and component placement deploys a highly accurate vacuum pipette, integrated into the heated head, which is controlled – as is the interchangeable heated head – by a stepping motor. An integrated force sensor recognizes contact with the component and the board.

Particularly appreciated by the user of the HR 550 is the optimal ergonomic design of the operating elements and the program supported component alignment with high-contrast, high-resolution images – the user-friendly operation of the system is further assisted by the newly developed operating software. The HR 550 is also ready for the use of the Ersa Dip&Print station, as it is for miniature components and removal of residual solder. With the Hybrid Rework System HR 550 Ersa is once again confirming its market-leading position in the rework technology – with a high-performance unit which convinces rework professionals and will support them in their work on the highest level.